Floor Area Ratio (FAR) Calculator for Plot in Delhi
Calculate FAR in Delhi
Calculators
Delhi
FAR Calculator Delhi
Construction Cost Calculator Delhi
Noida
FAR Calculator Noida
Construction Cost Calculator Noida
Gurgaon
FAR Calculator Gurgaon
Construction Cost Calculator Gurgaon
Faridabad
FAR Calculator Faridabad
Construction Cost Calculator Faridabad
Our FAR Calculator will give you
Maximum Gross Permissible Area
Maximum Number of Floors
Maximum Height of the Building
Areas in the home which are not included while calculating the FAR.
Calculators
Delhi
FAR Calculator Delhi
Construction Cost Calculator Delhi
Noida
FAR Calculator Noida
Construction Cost Calculator Noida
Gurgaon
FAR Calculator Gurgaon
Construction Cost Calculator Gurgaon
Faridabad
FAR Calculator Faridabad
Construction Cost Calculator Faridabad
Floor Area Ratio (FAR) calculation for plot in delhi As per local Building By Laws
Step 1:
Check the Floor area ratio (FAR) for your plot in Delhi from the table below. If you have the plot size in sq. yards then make sure to convert it to sq. m by multiplying it by 0.83. The table shown below is only applicable for plots in Delhi.
Area of Delhi
Plot (sq. meter)
Max. Ground
Coverage %
FAR
No. of Dwelling
Units
Below 32
90*
350
3
Above 32 to 50
90*
350
3
Above 50 to 100
90*
350
4
Above 100 to 250
75**
300**
4
Above 250 to 750
75
225
6
Above 750 to 1000
50
250
9
Above 1000 to 1500
50
200
9
Above 1500 to 2250
50
250
12
Above 2250 to 3000
50
200
15
Above 3000 to 3750
50
200
18
Above 3750
50
200
21
Step 2:
To take an example, say, your plot size is 300 sq. yards. Convert 300 sq. yards to sq. meters by multiplying it by 0.83. After conversion 300 sq. yards comes out to be 250 sq. meters.
For a 250 sq. meters plot in Delhi the FAR = 300 (as checked from the table).
FAR = (Total area of all floors * 100)/ Plot Area
Therefore, Total area of all floors = (FAR*Plot Area)/100
Total area of all floors for 300 sq. yards = (300*300*9)/100 = 8100 sq. ft.
(Factor of 9 has been used to convert plot size from sq. yards to sq. ft.)
Step 3:
If you are planning to consume the full FAR of your plot in Delhi then according to the Delhi By Laws you can only build 4 floors. Therefore the per floor coverage area comes out to be 8100/4 = 2025 sq. ft.
Note:
Balconies, Stilt Parking, Basement, Lift Shaft & Mumty are excluded from Floor area ratio (FAR) calculations. This list is not exhaustive and certain areas may get added during finalisation of drawings
FAR Calculator
Find permissible built-up area and ground coverage as per applicable Floor Area Ratio.
Note: These estimates are indicative. The final figure depends on drawings, specifications, authority norms and site condition. For an accurate quote, please contact our team.