Floor Area Ratio (FAR) Calculator for Plot in Noida
Calculate FAR in Noida
Calculators
Delhi
FAR Calculator Delhi
Construction Cost Calculator Delhi
Noida
FAR Calculator Noida
Construction Cost Calculator Noida
Gurgaon
FAR Calculator Gurgaon
Construction Cost Calculator Gurgaon
Faridabad
FAR Calculator Faridabad
Construction Cost Calculator Faridabad
Our FAR Calculator will give you
Maximum Gross Permissible Area
Maximum Number of Floors
Maximum Height of the Building
Areas in the home which are not included while calculating the FAR.
Calculators
Delhi
FAR Calculator Delhi
Construction Cost Calculator Delhi
Noida
FAR Calculator Noida
Construction Cost Calculator Noida
Gurgaon
FAR Calculator Gurgaon
Construction Cost Calculator Gurgaon
Faridabad
FAR Calculator Faridabad
Construction Cost Calculator Faridabad
Floor Area Ratio (FAR) calculation for plot in noida As per local Building By Laws
Step 1:
Check the Floor area ratio (FAR) for your plot in Noida from the table below. If you have the plot size in sq. yards then make sure to convert it to sq. m by multiplying it by 0.83. The table shown below is only applicable for plots in Noida./p>
Area of Noida
Plot (sq. meter)
Max. Ground
Coverage %
FAR
Below 50
75
180
Above 51 to 75
75
180
Above 201 to 300
75
180
Above 301 to 400
65
180
Above 401 to 500
65
180
Above 601 to 750
60
150
750 and Above
60
150
Step 2:
To take an example, say, your plot size is 300 sq. yards. Convert 300 sq. yards to sq. meters by multiplying it by 0.83. After conversion 300 sq. yards comes out to be 250 sq. meters.
For a 250 sq. meters plot in Noida the FAR = 180 (as checked from the table).
FAR = (Total area of all floors * 100)/ Plot Area
Therefore, Total area of all floors = (FAR*Plot Area)/100
Total area of all floors for 300 sq. yards = (300*180*9)/100 = 4860 sq. ft.
(Factor of 9 has been used to convert plot size from sq. yards to sq. ft.)
Step 3:
If you are planning to consume the full FAR of your plot in Noida then according to the Noida By Laws you can only build 3 floors. Therefore the per floor coverage area comes out to be 4860/3 = 1620 sq. ft.
Note:
Balconies, Stilt Parking, Basement, Lift Shaft & Mumty are excluded from Floor area ratio (FAR) calculations according to the Noida Building Bye Laws. This list is not exhaustive and certain areas may get added during finalisation of drawings
FAR Calculator
Find permissible built-up area and ground coverage as per applicable Floor Area Ratio.
Note: These estimates are indicative. The final figure depends on drawings, specifications, authority norms and site condition. For an accurate quote, please contact our team.